My Account
My Lists
My Orders
My Invoices
Track My Order
From one wall switch, the user turns both the lights and fan on at the same time. When the lights are manually turned off from the switch, the fan continue to run for a set time delay, then switches off automatically
- Continues to eliminate steam and odour after turning the lights off and leaving the bathroom
- Designed to be installed behind a wall plate (wall plate not supplied with the timer)
- Dimensions 39mm x 41mm x 12mm
- Delay can be set to 5, 15 or 30 minutes (15 minutes default)
- Works in conjunction with a standard switch mechanism (not supplied with the timer)
- No Neutral connection required at the timer
- Maximum Load 1A, Minimum Load 2.5W
| Supply | 220 – 240V, 50Hz |
| Max Load | 1A (all load types) |
| Min Load | 2.5W |
| Compatible Load Types | Resistive loads Inductive load (contactor coil) Tungsten filament lamp load Externally ballasted lamp load (LED, CFL or Fluorescent) Self-ballasted lamp load (LEDi or CFLi) Small motor load – M.1 (exhaust fan typical) |
| Fan Turn-On Delay | 3 seconds (default) 1 minute 3 minutes |
| Fan Turn-Off Delay (run-on time) |
5 minutes 15 minutes (default) 30 minutes |
| Switch Input type | Toggle ON/OFF |
| Load Switching type | Semiconductor switching device |
| Dimensions | 39 x 41 x 12 mm |
| Weight | 20g |
| Ingress protection | IP30 |
| Wire length | 110 mm |
| Ambient Operating Temperature | 0 to 50°C |
| Ambient Storage Temperature | -10 to 70°C |
| Humidity | 0% to 95% RH non-condensing |
| Fault Protection | Open circuit Short circuit Overload Over temperature |
| Material | Flame retardant polycarbonate |
